2011 Acura MDX Oil Type: The process of keeping the 2011 Acura MDX in good condition requires regular oil changes to ensure smooth performance And long life for the engine.
However, selecting the right oil, understanding the capacity, And knowing about the different filter options could appear daunting. Don’t worry, you’re an intrepid driver!
This complete guide, derived from Acura’s official sources As well As recent market data, delves into the MDX oil change process for 2011. MDX changing oil process.
2011 Acura MDX Oil Type
Acura officially endorses the full synthetic oil 0W-20 for the 2011 MDX. The oil is low-viscosity and flows easily even in cold temperatures, supplying essential lubrication starting at startup And guarding against wear due to high temperatures in operation.
While 5W-20 conventional oil is technically suitable, going for synthetic oil offers greater protection As well As longer change intervals.
2011 Acura MDX Oil Capacity
The engine in your 2011 MDX has 5.4 quarters of oil after the change of the filter. It is important to keep this amount available before making the oil replacement.
2011 Acura MDX Oil Filter
Acura suggests using their original oil filter (part number 15400-P5S-01) to ensure optimal functionality and compatibility.
However, A variety of high-quality filters available from the aftermarket, such as Wix 57356 And Fram PH8943, can meet or surpass OEM specifications And provide alternatives.
2011 Acura MDX Oil Change Cost
The cost for the oil change on your 2011 MDX is contingent upon the location, type of filter, And oil if you decide to DIY or go to A repair shop.
Expect to spend between $68 to $104 for a full oil change At A local shop, whereas dealerships could be A bit more expensive. DIYers can save money by buying filters and oil for themselves, spending an average of $30-$50.
2011 Acura MDX Engine Specs
The 2011 Acura MDX features a 3.7-liter SOHC VTEC V6 engine generating 300 HP at 6,300 rpm and 270 lb-ft of torque at 4500 rpm. It connects to a six-speed automatic transmission with a manual mode.
The following are a few of the key specifications for the engine:
| Specification | Value |
|---|---|
| Displacement | 3.664 liters (223 cu in) |
| Horsepower | 300 HP (224 Kw) at 6,300 RPM |
| Torque | 227 pounds (366 Nm) @ 4,500 rpm |
| Transmission | 6-speed auto with manual mode |
| Economy of fuel | 16 mpg city/21 highway |
| 0-60 at mph | 6.5 seconds |
2011 Acura MDX Oil Change
- The engine should be warmed up for A few minutes to let the oil loosen.
- Place your vehicle on a level area and switch off your engine.
- Unscrew the hood And find the drain plug for oil. It’s typically located in the middle of the oil pan, close to the front of the engine.
- Place the drain pan for oil beneath the plug for draining.
- Release the drain plug using the socket wrench, and let the oil be completely drained into the pan.
- When the oil has gone down, take out the old filter. It is possible to employ An oil wrench to do this.
- Apply A thin layer of oil on the gasket of your fresh oil filter.
- Install the new filter with your hands until it’s snug Then tighten it another 1/4 turn using the wrench for oil filters.
- Install A new drain pipe, and make sure you tighten it to the required torque (consult your owner’s guide).
- Add the oil that you have just changed, but be mindful not to overfill. The capacity of your MDX for 2011 MDX is 5 Quarts.
- The oil level should be checked At the bottom of your dipstick. The level of oil should be in between the marks of the dipstick.
- The engine should be started And allow it to run for a couple of minutes. Examine for leaks around the drain plug And the oil filter.
- Shut off the engine, And check the level of oil. You can add more oil if needed.
FAQs – Acura MDX Oil Type 2011
What type of oil do you use in your Acura?
I prefer using syn oil in my 06 TSX (159K) and 11 MDX (129K) because of the extreme temp range we can get in the southwest (08 RDX @163K requires syn oil). All Acuras suggest full synthetic. I have always switched my cars to full synthetic at the first oil change.
What kind of oil should I use in my MDX?
A family hauler like the MDX will never push 0W-40 oil at all, The engine is simply too weak for it. On the other side 0W-20 is so light even in the MDX is pushing it.. It is better designed for smaller weaker 4cyls.
Can I use synthetic oil in my 2018 MDX sport hybrid?
The manual for my 2018 MDX Sport Hybrid recommends conventional oil and says I can use synthetic if I wish. Just had the car in for the tail light recall and got the oil changed.
People Also Search acura mdx oil type 2011
| recommended oil for Acura MDX |
| 2011 acura mdx oil change |
| the best oil for Acura MDX |
| 2011 acura mdx oil capacity |
| oil for 2012 acura mdx |
| acura mdx 2011 oil type |
| Acura oil consumption recall |
| 2011 acura mdx burning oil |
Conclusion:
Utilizing the suggested use of the 2011 Acura MDX oil type is vital to maintain the health of your car’s engine and long-term durability.
It gives you the best performance and protects against wear and tear to the engine making sure your engine operates effortlessly and effectively.
Select the correct oil by comparing the viscosity ratings of synthetic and. traditional oil types, the driving conditions, and the manufacturer’s guidelines.
Make sure you have an oil change from a trusted mechanic who adheres to the recommended interval for oil changes and utilizes the appropriate oil type.
If you follow these steps by following these guidelines, you can keep the 2010 Acura MDX running smoothly and efficiently for many years to be.
Be aware that making sure you take care of your car’s engine will ensure its durability and enjoyment on the road.