Coolster 110cc ATV Oil Type, Capacity, Filter & Change Cost

Coolster 110cc ATV Oil Type:  The Coolster 110cc ATV requires frequent oil replacements to ensure it’s operating smoothly and to avoid expensive repairs. 

What type of oil should you choose what amount do you require and how often do you need to change it? In this article, I’ll address all your questions and guide the steps to changing the oil in your ATV by yourself.

oil type: The Coolster 110cc ATV requires 10W-40 motorcycle oil. This type of oil was specifically made for high-performance engines and is able to withstand extremely high temperatures, and conditions ATV operate.

Capacity for Oil: The Coolster 110cc ATV has a capacity for crankcase oil of 1.1 quarters. Use the right amount of oil in order to avoid overfilling or underfilling your engine.

Oil Filter: The Coolster 110cc ATV has a GY6110 oil filter. This kind of filter is easily available in most auto parts shops.

Oil change cost: The cost to change the engine oil on the Coolster 110cc ATV is going to differ based on the location where you’re doing it and the type of oil that you make use of. You should expect to pay between $20 and $30 for a simple oil change.

Coolster 110cc Oil Type

Here is some information based on your search results about the Coolster 110cc oil type.

• Recommended oil is Motorcycle/ATV Oil
• Use 10w40 oil in cooler weather. Use 20w50 oil in hotter temperatures (above 60degF).
• Just under 1 quart is required for the engine.
• Use JASO MA-rated lubricant if the ATV is equipped with a wet clutch. Shell Rotella T6 and Valvoline 10W40 ATV oil are recommended.
• For 110cc and 125cc engines, add around 1/2 quart (500ml) and 3/4 quart (750ml), respectively, of oil.
• It is important that the oil be Jaso Ma/ma2 Certified.

The recommended oil for the Coolster ATV 110cc is Motorcycle/ATV Oil, 10w40 for cooler weather, and 20w50 for warmer weather. Just under 1 quart is needed for the engine. Use JASO MA-rated oils, such as Shell Rotella T6 or Valvoline ATV10W40, if the ATV is equipped with a wet clutch. Use Jaso ma/ma2 oil and add approximately half a quart of oil to 110cc models.

Coolster 110cc Oil Capacity

Here is the Coolster 110cc oil capacity based on your search results:

• Just under 1 quart is required for the engine.
• Add approximately 500ml of oil to 110cc models.
• Oil for a 110cc is 0.8 liters.

The oil capacity of the Coolster ATV 110cc is approximately 1 quart. Add approximately half a quart of oil (500ml). The 110cc engine also requires 0.8 liters of oil.

Explore the Coolster 110cc ATV

Coolster ATV 110cc: Overview

Coolster produces high-quality ATVs. The Coolster 110cc is one of the most popular models. These ATVs cater to riders of every age and ability level, providing a balance between power and durability.

Engine Specifications

Coolster ATVs come with an air-cooled 110cc single-cylinder engine. This powerful engine ensures fuel efficiency while providing enough power for off-road excursions. To maintain the engine’s performance, it is essential to use the proper oil type.

Coolster 110cc ATV Oil Filter

This Coolster 110cc ATV is equipped with a 27 mm oil filter for engines. It’s a spin-on filter, which means that it is removed and put on manually. The filter is on the left-hand right side of your engine just below the cylinder head.

Here are some well-known brand names of engine oil filters with 27mm that work for the Coolster 110cc air-tight vehicle:

• Promax
• K&N
• HiFloFiltro
• Fram
• Wix

It is crucial to utilize an oil filter of high quality to ensure your engine is protected. Filters trap debris and dirt in the engine oil. This aids in keeping your engine running clean and in good condition.

How to Change Oil in a Coolster110cc ATV

Gather the tools and supplies you need

Draining old oil 

The oil drain plug is located under the ATV. Place the oil pan beneath the plug. To drain the old oil, loosen the plug with a hex wrench.

Oil Filter Replacement

Remove the old engine oil filter by using an oil filter wrench. Apply a thin oil layer to the rubber seal of the new filter and install it manually. Tighten the new oil filter by hand until it is snug.

Refilling Oil

Refer to the Coolster user guide to determine your Coolster’s oil capacity. Pour the new lubricant slowly into the designated port. Once the fill port is full, replace the cap.

Checking oil levels

People Also search for coolster 110cc ATV oil type

For more posts visit our website: https://engineoiil-capacity.com/

Conclusion

FAQs – coolster 110cc atv oil type

What is the minimum age to ride a coolster ATV?

Riders should recommended to be 16 years of age or older for all other Coolster vehicles. If you require additional guidance regarding ATV training, we recommend enrolling in an ATV Safety Institute (ASI) training course.

What type of oil does a Kazuma Falcon 110 ATV use?

In hotter climates where temperatures exceed 100ºF, it is recommended to use a thicker 20W-40 oil. Changing the oil on a Kazuma Falcon 110 ATV is relatively simple and requires only a socket wrench, a 17 mm socket, a torque wrench, an oil catch pan, and a few rags.

Why choose coolster for your next off-road vehicle?

Whether you’re in search of an ATV, dirt bike, or go-kart, everything you’ll discover from Coolster comes with our assurance of quality. Our off-road vehicles, leading in their class, are meticulously designed for your enjoyment, comfort, and safety.

When should I schedule the initial oil change for my ATV?

Break in oil (only) changes at 25 hours, 1 month, or 155 miles, depending on which comes first. Next, you will need to change your oil and filter every 100 hours, 6 months, or 620 miles.

What kind of transmission does a coolster qg-210 have?

The Coolster QG-213A dirt bike features a fully automatic transmission with an upgraded adjustable rear shock for a stable and comfortable ride. Like the QG-210, the QG-213A is identical except for its larger 110cc engine.