Yamaha Road Star 1700 Oil Type, Capacity, Filter, & Engine Specs

Yamaha Road Star 1700 Oil Type, Capacity, Filter, & Engine Specs

Yamaha Road Star 1700 Oil Type: Maintain Your Yamaha Road Star 1700 running effortlessly with the correct oil type capacity, filter, And the cost of changing it.

In this post, I’ll explain all that you should know about how to ensure that your Road Star’s engine is in good shape and safe.

Type of oil: Yamaha recommends using synthetic oil that has a viscosity of around 10W-40 in the Road Star 1700. This kind of oil is specifically designed to safeguard your engine from all weather conditions and also to extend the lifespan of the engine.

Capacity of oil: The oil capacity of your Road Star 1700 is 4.2 Quarts. Be sure to check the oil level frequently And Add additional oil if you need to.

Filter for oil: Yamaha advises you to change your oil filter when it is time to change the oil. The oil filter assists in keeping debris And dirt out And helps keep your motorcycle’s oil free of contaminants.

Oil change costs: The cost of an oil change on the Yamaha Road Star 1700 varies according to where you get the work done. It is possible to spend between $30 And 70 dollars for An oil replacement in An independent shop or A dealership.

Yamaha Road Star 1700 Oil Type

The Yamaha Road Star 1700’s most recommended oil is 20W-40 or 20W-50 synthetic motorcycle oil, as stated in the owner’s manual.

Opt for the highest-quality oil that meets or surpasses the manufacturer’s specifications for maximum performance and protection.

Refer to the owner’s guide or seek advice from a qualified mechanic for specific recommendations on oil and proper intervals for oil changes.

Yamaha Road Star 1700 Oil Capacity

The capacity of the oil in the Yamaha Road Star 1700 is roughly 5.28 US quarts (or 5.0 milliliters) after replacing the oil filter. It is 4.76 US quarts (or 4.5 milliliters) in the absence of replacing the filter.

Consulting the owner’s manual for details on oil capacity and proper changing procedures ensures that the engine functions properly and is lubricated.

Carefully gauging the oil level following an oil swap is crucial to avoid damage to engines caused by overfilling or underfilling.

Yamaha Road Star 1700 Oil Filter

The Yamaha Road Star 1700 uses an oil filter specifically created for motorcycles. The suggested oil filter is Yamaha part number 5GH-13440-50-01 or the similar K&N oil filter number KN-303.

Selecting a high-quality oil filter that complies with or surpasses the manufacturer’s specifications is crucial for maximum engine protection.

When replacing the oil filter, consider replacing the O-rings on the oil filter cover to prevent potential oil leaks.

Refer to the owner’s manual or seek advice from an experienced mechanic for tips on oil filters and procedures for changing oil.

Yamaha Road Star 1700 Engine Specs 

The engine specifications of the Yamaha Road Star 1700

FeaturesSpecification
Engine TypeAir-cooled 4-stroke V-twin SOHC
Displacement1690cc (103.7 cu in)
Bore & Stroke90mm x 103mm (3.54″ x 4.06″)
Horsepower106 hp at 4500 rpm
Torque112 lb.-ft. @ 3000 rpm
Fuel SystemElectric fuel injection
Ignition systemDigital TCI
Starting SystemElectric starter
Transmission5-speed manual with Overdrive
Final DriveShaft drive
Cooling SystemAir-cooled
Oil Capacity4.5L (4.76 US qt)
Oil Change IntervalOwner’s Manual

 Yamaha Road Star 1700 Oil Change 

To change the oil in the Yamaha Road Star 1700, you’ll need to take these steps

  1. Start by warming your engine until it is at a comfortable temperature.
  2. Shut off the engine and place your bicycle on a stand or elevate it with a Jack.
  3. Find the drain plug for oil at the bottom on the bottom of the engine.
  4. Put a drain pan on the drain plug, then remove it to let out all the oil.
  5. After the oil has gone through and the drain plug is replaced, you can replace it and make sure it is tightened.
  6. Find the oil filter on the back of the engine. Remove it.
  7. Apply a small amount of liquid to the gasket on the oil filter, and then install it.
  8. Inject new oil into the engine according to the recommended oil type and quantity.
  9. Begin the engine, and let it run for a couple of minutes. Then, take a look at the oil level, and add more.

Conclusion

Using the recommended type of oil for the Yamaha Road Star 1700 is crucial for ensuring engine performance and increasing the lifespan of your motorcycle.

Regular oil changes And level checks Are also essential for ensuring that your motorcycle is running well and smoothly.

If you follow these easy guidelines, you can make sure the Yamaha Road Star 1700 remains in top condition for many years to come.

For more posts visit our website: https://engineoiil-capacity.com/

FAQs – Yamaha Road Star 1700 oil type

When was the Yamaha Road Star 1600 discontinued?

Yamaha discontinued the Road Star 1600 after the 2003 model year, increasing the engine size on the Road Star for the 2004 model year to 1670 cc and renaming it the Road Star 1700. The Yamaha Road Star 1600 has an air-cooled, twin-cylinder, OHC engine with four valves per cylinder. A 40 mm Mikuni carburetor delivers the fuel to the engine.

What kind of engine does a Yamaha Road Star 1600 have?

The Yamaha Road Star 1600 has an air-cooled, twin-cylinder, OHC engine with four valves per cylinder. A 40 mm Mikuni carburetor delivers the fuel to the engine.

What kind of oil should I use in my Yamaha?

As long as an oil meets both of those requirements you’re good to go. Unfortunately, Yamalube no longer provides oil that meets both these requirements. The safe bet is a V-Twin-specific oil. The most popular is Mobil 1 V-Twin, but there are several other brands that will also work.