2014 Chevy Silverado Oil Type, Capacity, Filter, & Change Cost

2014 Chevy Silverado Oil Type: Maintain Your 2014 Chevy Silverado running efficiently by choosing the correct type of oil capacity, filter size, and cost of change.

 In this article, I’ll explain all that you should know about how to ensure that your Silverado’s engine is healthy and happy.

Oil Type: The recommended type of oil for 2014. Chevy Silverado is certified dexos1 synthetic oil 0W-20 or 5W-20. Dexos1-certified oil is in compliance with or exceeds Chevrolet’s requirements to protect the engine and provide performance.

Capacity: The capacity of oil for the 2014 Chevy Silverado varies based on the size of the engine. In the case of 4.3L V6 or 6.0L V8 motors, the capacity of oil of 6 quarts. for those with the 5.3L V8 as well as 6.2L V8 engine, the capacity of oil is 8.5 cubic inches.

Filter: The ideal oil filter to use on a 2013 Chevy Silverado is ACDelco PF4967R. The filter was designed in order to eliminate harmful contaminants from the Silverado’s engine oil, thereby helping safeguard the engine.

Change Cost: The cost for an oil change on the 2014 Chevy Silverado can vary based on the location you are in and the kind of oil you make use of. You can anticipate to spend between $50- $100 for a basic oil change.

Engine Oil Recommendations for the 2014 Chevy Silverado

The recommended engine oil for the 2014 model is a GM-approved dexos1TM motor oil with a weight of either 5W-30 or 5W-20, according to the owner’s handbook for the 2014 Chevy Silverado.

This specification is a GM-specific motor oil standard made to improve the fuel efficiency and engine performance of GM cars.

It is always advised to consult the owner’s manual for precise oil recommendations for your individual Chevy Silverado make and model.

The handbook advises using an oil filter that complies with GM Standard GM 18M01 or has the appropriate oil filter part number in addition to the approved oil type.

2014 Chevy Silverado oil Capacity

The capacity of oil for the 2014 Chevy Silverado may differ depending on the type of engine and the configuration. Here are some common engine choices as well as their capacity for oil:

1. 4.3L V6 Engine About 6 quarts (5.7 Liters) of oil.
2. 5.3L V8 Engine About 8 cubic quarts (7.6 milliliters) of oil.
3. 6.2L V8 Engine About eight quarts (7.6 milliliters) of oil.

Be aware that these estimates are general and it is important to check your vehicle’s owner’s manual to find the exact capacities of the oil that are applicable to the specific model of your engine. 

The oil that is overfilled or underfilled can affect engine performance, therefore it’s crucial to keep the proper oil level.

2014 Chevy Silverado Oil Filter

In the case of the 2014 Chevy Silverado, the oil filter you’ll require will differ based on your engine’s model and configuration.

 It is recommended to consult the owner’s manual for your vehicle or talk to an expert mechanic to determine the correct part number for the Silverado’s engine.

In general, the most well-known oil filter manufacturers such as AC Delco, Fram, Purolator as well as Mobil 1 offer compatible filters for various engines included in 2014’s Chevy Silverado collection. 

To ensure that you receive the correct oil filter, you must provide the specifics of your vehicle like the engine’s size when you purchase the filter.

2014 Chevy Silverado Oil Change

In order to change your oil for the 2014 Chevy Silverado, you must follow these steps:

1. Place your vehicle on a level surface.
2. Shut off the motor and allow it to cool for a couple of minutes.
3. Open the hood and find the cap that fills up the oil. Unclip the cap.
4. Install your oil-draining pan beneath the drain plug. The plug for draining oil is located at the top of the pan.
5. Use a socket or wrench to remove the drain plug. Be aware that the oil is hot.
6. Let the oil run off into the drain pan.
7. After the oil has been gone down it is time to replace the drain plug, and then tighten the bolt using the socket or wrench.
8. Take out the old filter. You could make use of the wrench for oil filters to do this.
9. Apply a thin layer of oil that is new to that gasket on the oil filter that has been replaced.
10. Install the new filter with your hands until it’s snug. Do not over tighten.
11. Remove the cap on the oil filler out of the engine.
12. Inject new oil into the engine. What amount that you will need to add is contingent upon the engine’s size. Refer to the owner’s manual to determine the proper amount of oil you need to add.
13. Replace the cap on the oil filler.
14. Begin the engine, and let it run for a couple of minutes.
15. Make sure the oil is at the right level, and add oil if needed.
16. Switch off the engine and cover the front of your hood.

Also, Related some Articles:

Volkswagen Passat ii Engine Oil Capacity

Renault Megane Scenic (1996 – 1999) Engine Oil Capacity

Volkswagen Lupo Engine Oil Capacity

People Also Searches 2014 Chevy Silverado oil type

Conclusion:

The right oil to use on your 2014. Chevy Silverado is a crucial aspect of keeping your truck running efficiently.

While the most recommended oil would be Dexos1 Gen 2, there are other options also, depending on your requirements and financial budget.

Make sure you adhere to the recommended interval for oil changes and select the appropriate weight of oil to prevent damage to your engine and ensure maximum performance. Maintaining your 2014 Chevy Silverado will extend its lifespan.

For more posts visit our website: https://engineoiil-capacity.com/

FAQs – 2014 Chevy Silverado oil type

In what kind of oil should a Chevy Silverado be put?

A conventional or synthetic mix motor oil with a weight of either 5W-30 or 5W-20 and the API starburst symbol on the container, which denotes that it complies with industry standards set by the American Petroleum Institute, is normally the recommended oil for a Chevy Silverado. For detailed oil recommendations for your specific Chevy Silverado make and model, it’s vital to consult the owner’s manual.

How much oil does a 2023 Chevy Silverado take?

How Much Oil Does a Chevy Silverado Take? The 2022 6.2L Chevy Silverado takes 8 quarts (7.6 liters) of 0W-20 oil with a filter. Check the engine oil level on a regular basis, at least once every 650 kilometers (400 miles), especially before a lengthy journey.

How much oil does a 2017 Chevy Silverado hold when idle?

I have a 2017 Silverado 5.3L. Used to stay around 40 pounds of oil. Now when idling, it goes down to 20-25 ish pounds. It’s not throwing any codes up but does have a bit of a knock if I floor it without letting the pressure build back up first.

What kind of oil should the 2014 Chevy Silverado 1500 recommend?

The answer is Chevrolet suggests using ACDelco fully synthetic motor oil for all oil changes on the 2014 Chevy Silverado 1500.