2012 GMC 5.3 Oil Type: Looking for the right kind of oil to make use of in the 2012 GMC 5.3L V8 engine? How much oil will need to be used? How often do you need to change it?
Take a look! In this blog, I’ll be able to answer all your questions regarding the 2012 GMC 5.3 the type of oil capacity, filter size, and the cost of changing it.
Oil Type: In 2012, the GMC 5.3L V8 engine is powered by the synthetic 5W-30 oil. Synthetic oil can be more costly than standard oil, but it comes with numerous advantages, such as better quality, performance, as well as efficiency in fuel consumption.
Capacity Of Oil: The capacity of oil for this 2012 GMC 5.3L V8 engine is 6 cubic inches when it has a filter and 5.5 cubic quarts with no filter.
Oil Change Interval: The recommended interval for oil changes of the 2012 GMC 5.3L V8 engine is 7,500 miles. six months, or whichever is first. But, if you are driving in extreme conditions, like traffic that is smoky or stop-and-go it is possible be changing your engine oil more frequently.
Oil Change Cost: The price of an oil replacement for 2012. GMC 5.3L V8 engine is different depending on the location of the engine and the kind of oil being used. The typical price is between $50 and $100.
2012 GMC 5.3 Oil Type
The recommended oil for a GMC 5.3L engine in 2012 is 5W-30. GMC 5.3L engine would be 5W-30. It is a synthetic blend oil that provides excellent protection for your engine under a range of different driving situations.
But, you might be interested in an all-synthetic oil like 0W-20 or 5W-20 for those who live in colder climates or in the event that you are involved in lots of driving that is heavy-duty.
Here are some oil suggestions for the GMC 5.3L engine in 2012. GMC 5.3L engine.
- Mobil 1 Extended Performance 5W-30 Synthetic Motor Oil
- Castrol EDGE 5W-30 Advanced Full Synthetic Motor Oil
- AMSOIL OE 5W-30 Synthetic Motor Oil
- AMSOIL Extended-Life 5W-30 100% Synthetic Motor Oil
Whatever oil you pick, be certain to consult the owner’s manual to determine the recommended intervals for changing oil.
Note that the recommendations above are general in their nature. Always go to the owner’s manual of your vehicle or a certified mechanic for the specifics of your vehicle.
2012 GMC 5.3 Oil Capacity
The capacity of oil in the 2012 GMC 5.3 engine is 6 quarts after an oil filter change. It includes all the oils stored in the filter.
Please note that the oil capacity may vary slightly based on your car’s specific trim level and model. For precise information, consult your owner’s manual.
2012 GMC 5.3 Oil Filter
The most recommended oil filter for 2012. GMC 5.3 engine will be ACDelco Pf48E. The filter is specifically designed to meet or surpass the performance standards that are set by General Motors.
It is constructed with top-quality materials and is constructed with high-quality materials. Additionally, it comes with a sturdy end cap made of metal and an anti-drain-back silicone valve.
Here are some more well-known options for oil filters that are suitable for a 2012 GMC 5.3 engine.
- K&N PS-1012
- Wix 57354
- Fram PH10060
- Mobil 1 M1-108
- Bosch 3300
When you are choosing one of the filters for your oil, it’s crucial to choose one that’s compatible with the engine of your car and the type of oil. Also, you should be aware of the filter’s performance capacity, durability, and capacity.
2012 GMC 5.3 Oil Change
- Get your engine warm for a couple of minutes. This will make the oil flow more smoothly.
- Make sure your vehicle is on a level area and shut off the engine.
- Lift the hood to locate the cap for filling up with oil. The cap should be removed and put aside.
- Place the drain pan for oil beneath the plug to drain oil. The plug that drains oil is located at the lower part of the pan.
- Utilize a socket or wrench to remove the drain plug. Be careful, because the oil is hot.
- Let the oil run off into the pan.
- After the oil has been run out and the drain plug is replaced, you can replace the plug. Then tighten it up with the socket or wrench.
- Take off the old filter. You can use a wrench for the oil filter to help you do this.
- Apply a thin layer of fresh oil on the gasket of the brand-new oil filter.
- Attach the new filter with your hands until it’s snug. Do not tighten too much.
- Introduce new oil to the engine via the neck for filling oil. Make use of the funnel to stop spills.
- Replace the cap that holds the oil.
- The engine should be started and allow it to run for a couple of minutes. Examine for leaks in the oil drain plug or the oil filter.
- Switch off the engine, and then look at the level of oil. If needed, add more oil.
- Close the hood, and you’re done!
It is essential to dispose of the old filter and oil properly. It is possible to take them to the local auto parts shop or recycling center.
FAQs – 2012 GMC 5.3 oil type
How much oil does the 2012 GMC Sierra 1500 take?
The 2012 GMC Sierra 1500 engine oil capacity is 6 US quarts (5.7 liters) for all engines except the 4.3L engine which requires 4.5 quarts (4.3 liters).
What kind of oil do you put in a Chevy 53?
There are just two types of engine oils recommended for vehicles with Chevy 5.3 engines. The oils are 5w30 and 0w20. GM Dexos-approved 5w30 oils are the best for your 1999 – 2013 Chevy 5.3 vehicles. However, the 2014 Chevy Suburban 5.3 and Tahoe 5.3 can use 5w30 oils, too.
What kind of oil does the 2010 Chevy Silverado take?
The 2010 Silverado, as well as most other Chevrolet Silverados with a 5.3 liter Vortec engine, require synthetic oil with a viscosity rating of 5W-30. Just so you know about viscosity ratings, the first number.
How many quarts of oil does a 2013 Chevy Silverado take?
A 1999 – 2013 Chevy Silverado 1500 with a 5.3L engine consumes 6 quarts of oil. Unlike the 1999 – 2013 models, the newer Chevy Silverado models built in 2014 have an oil capacity of 8 quarts. Your 2000 Chevy Silverado can take a maximum of 6 quarts of oil, SAE 0W-20 or 0W-30.
Conclusion
Thanks for reading this post about the new 2012 GMC 5.3 Oil type. I hope you found this information useful. If you’ve got any additional concerns, don’t hesitate to reach me.
To summarize the main aspects, the suggested oil type for GMC 2012 5.3 is synthetic 5W-30. It is more costly in comparison to conventional oils however it comes with a number of advantages, including improved performance at extreme temperatures as well as longer intervals for oil change.
If you’re not able to make use of synthetic oil, you may make use of conventional oil, but ensure that you replace it more frequently.
I hope this will be of use to you. Thank you for taking the time to read!