310 John Deere Oil Type: The maintenance of your John Deere tractor is essential for optimal performance and durability.
One of the most important aspects of this is the regular oil changes to ensure that the engine is properly lubricated and protected. the engine.
However, the myriad of different types of oil capacity filters, costs, and types can be A bit confusing.
Don’t worry, John Deere fans! This guide offers all the current, accurate information that you need to keep your John Deere 310 squealing like kittens.
310 John Deere Oil Type
The type of oil recommended for a 310 John deere is dependent on the particular type and model of your tractor and your operating environment. Here is a general guideline
| Oil Type | Recommend Use |
|---|---|
| SAE 30 | Warm weather |
| 10W-30 | Multi-viscosity is a must for any season. |
| 5W-30 | Cold weather |
| John Deere Hy-Gard(tm) | Premium oil that is suitable for all seasons |
310 John Deere Oil Capacity
The capacity of oil in a John Deere 310 depends on the model and engine you own. Here’s an overview of the capacities for a variety of typical models:
| Model | Engine | Capacity for Oil (Quarts) |
|---|---|---|
| 310A | 300 Series | 13 (with filter) |
| 310D | 4045D | 7 (without filter) |
| 310G | 4045D/4045T | 7 (without filter) |
| 310SL/410L | 4045D/4045T | 13 (with filter) |
310 John Deere Oil Filter
The filter that you will need for your 310 John Deere is dependent on the model and engine that you own.
The most popular oil filter that is used for all John Deere 310 versions is RE50732. This filter works with a range of engines, such as:
| Model Year | Type of Engine | Part Number of the Filter | Notes |
|---|---|---|---|
| Most Models | 300 Series, Yanmar | RE50732 | The most common filter is broadly compatible |
| 310A | N/A | RE55020 | The model is specific to the 310A model |
| 310D | N/A | RE504836 | Particular to the 310D model |
| 310G/310SG | N/A | RE50732 | You can also use the Donaldson P550020 |
310 John Deere Backhoe Weight
The John Deere 310 backhoe loader weighs approximately 12,750 lbs (5,783 kg). However, this weight can vary slightly depending on configurations and attachments.
With additional features or modifications, the maximum weight can reach up to around 16,000 lbs (7,257 kg), depending on the specific setup and equipment used.
John Deere 310D Specification
| General Specifications | |
| Model | John Deere 310D |
| Length | 6,850 mm (269.7 in) |
| Width | 2,130 mm (83.9 in) |
| Height | 3,650 mm (143.7 in) |
| Wheelbase | – |
| Weight | 6,170 kg (13,603 lbs) |
| Fuel tank capacity | 128.7 liters (34 US gal.; 28.3 Imp. gal) |
| Battery | 12V |
| Cabin type | Cab (optional) |
| Engine | |
| Engine model | John Deere 4039D |
| Engine type | Four-stroke, liquid-cooled, inline |
| Cylinders | 4 |
| Fuel type | Diesel |
| Displacement | 3.9 L, 3,916 cm2, (239.0 cu·in) |
| Bore and stroke | 106.0 mm X 110.0 mm (4.17 in X 4.33 in) |
| Horsepower | 70.7 PS (52.0 kW; 69.7 HP) at 2,200 rpm |
| Torque | 260.4 N·m (26.6 kg·m, 191.9 ft·lb) at 1,200 rpm |
| Starter | Electric |
| Oil capacity: | 8.5 L (9 US. qt, 7.5 Imp. qt.) |
| Coolant capacity: | 16.1 L (17 US. qt, 14.2 Imp. qt.) |
| Engine | |
| Engine model | John Deere |
| Engine type | Four-stroke, liquid-cooled, inline |
| Cylinders | 4 |
| Fuel type | Diesel |
| Displacement | 3.9 L, 3,916 cm2, (239.0 cu·in) |
| Bore and stroke | 106.0 mm X 110.0 mm (4.17 in X 4.33 in) |
| Horsepower | 76 PS (55.9 kW; 75 HP) at 2,200 rpm |
| Torque | 260.4 N·m (26.6 kg·m, 191.9 ft·lb) at 1,200 rpm |
| Starter | Electric |
| Oil capacity: | 8.5 L (9 US. qt, 7.5 Imp. qt.) |
| Coolant capacity: | 16.1 L (17 US. qt, 14.2 Imp. qt.) |
310 John Deere Oil Change
- Gathering Supplies: You’ll need the proper oils (refer to the previous prompts for suggestions) Oil filter (see the table from the previous prompt) as well as a funnel for draining oil socket wrenches and rags as well as safety eyewear.
- Warm-Up Engine: The engine must be run for a short time to warm the oil, which makes it easier to drain.
- Parking and Security: Park on a flat surface and use your parking brake.
- Locate Drain Plug: Locate the drain plug for engine oil usually located at the lower part of the crankcase.
- Drain Oil Put: the pan underneath the plug and gently loosen it with a wrench. Allow the oil to go away completely.
- Replace the Oil Filter: Use a wrench to pull out your old filter. Apply a thin layer of oil onto the seal of your new filter, and fix it in place by hand. After that, make sure to tighten it using the wrench (don’t overtighten).
- Refill with oil: Check your owner’s manual to determine the proper capacity of oil (varies according to the model). Start adding oil slowly, checking the dipstick until you reach the mark of full.
- Clean up: Dispose of used oil and filter with care. Clean up any spills.
- Begin Engine, and check: Start the engine and examine to see if there is any leaks near the drain connector and the filter. Check that the gauge on your dashboard is within the normal range.
- Reset Service Reminder: When your tractor is equipped with an oil change reminder, set it to reset according to the owner’s guidelines.
FAQs – 310 John Deere oil type
What kind of oil does a John Deere 310A take?
Oil capacity is 9 quarters. John Deere recommends Plus 50-15W 40 for four-cylinder diesel engines. The cooling fluid keeps this backhoe cool. Air-cooled, 16-quart 310A. The reverser hydraulic 310A transmission has an eight-speed collar.
When did the John Deere 310D backhoe loader come out?
The John Deere 310D backhoe loader was first introduced in the early 1990s as part of the company’s 300D series of construction equipment. It was in production for several years and was eventually replaced by newer models. However, you can still find used versions of the 310D for sale on the secondary market. The specific year of release may vary based on the country or region of the market.
What kind of engine does a John Deere 310sl have?
310L | Backhoe | John Deere US Explore the 310SL backhoe loader with FT4 emission-certified engine, clutchless gear changes, and redesigned pilot tower. View more features and specifications.
Also, Related some Articles:
Toyota Corolla, E15 Engine Oil Capacity
Toyota Camry (1987 – 2004) Engine Oil Capacity
Conclusion
ensuring you are using the right type of oil and capacity is vital to the longevity and smooth operation of your John Deere engine.
Based on information from the official sources 15W-40 oil is the recommended type and has capacities of 6 quarts and the M806418 or M806419 filter. The following guidelines can aid in keeping your engine operating optimally.
It’s essential to reference the owner’s manual for the most up-to-date details. I hope this post can be of help to you in taking care of your car.
Thank you for spending some time and reading through this blog. Enjoy your day and great motoring!
For more posts visit our website: https://engineoiil-capacity.com/