2015 Chevy Suburban Oil Type: The maintenance of the 2015 Chevy Suburban requires more than filling up the tank with gas.
Routine oil replacements are essential for optimum performance, and long-lasting engine life as well as avoiding costly repairs down the line.
However, with a variety of oil types capacities, filters, and choices, the world of Suburban oil changes can be a bit confusing.
This guide, derived from official Chevrolet documentation as well as reliable online sources, will provide you with all the necessary details you require to ensure that your vehicle runs as smoothly as the way you want it to.
2015 Chevy Suburban Oil Type & Capacity
The recommended oil to use on your 2014 Suburban should be SAE 0.W-20 particularly Dexos(r)-approved oil.
This light, synthetic blend offers optimal protection and lubrication for your engine over a broad temperature range.
Be aware that using anything other than Dexos(r)-approved oil may cause warranty cancellation and you should stick to the recommendations of the manufacturer to ensure security.
2015 Chevy Suburban Oil Capacity
The capacity of the oil in your Suburban in 2015 Suburban is dependent on the engine it’s fitted with:
| Engine | Oil Capacity (Quarts) |
|---|---|
| 5.3L V8 | 6.0 |
| 6.2L V8 | 7.0 |
2015 Chevy Suburban Oil Filter
The right oil filter to fit your 2014 Suburban should be ACDelco Pf48. This premium filter efficiently traps particles and dirt, assuring the oil circulates cleanly throughout your engine.
2015 Chevy Suburban Oil Change Cost
The price of a new oil for your Suburban for the year 2015 Suburban will vary based on the location, the type of oil you use, and the option to do the work yourself or take it to a store. This is a basic breakdown:
| Location | DIY Cost | Shop Cost (Range) |
|---|---|---|
| Home | $30-$50 | $50-$100 |
| Independent Shop | $50-$75 | $75-$115 |
| Dealership | $75-$100 | $95-$125 |
2015 Chevy Suburban Engine Specs
Here are some additional specs of the new year 2015 Chevrolet Suburban EcoTec3 5.3L V8 engine:
| Specification | Value |
|---|---|
| Engine | EcoTec3 5.3L V8 (L83) |
| Displacement | 325 cu in (5328 cc) |
| Stroke and bore | 3.78 inches x 3.62 inches (96 x 92.5 millimeters) |
| Horsepower | 355 HP (250 4 kW) at 5600 RPM |
| Torque | 383 lb-ft (519 Nm) @ 4100 rpm |
| Compression ratio | 11.0:1 |
| Fuel type | Regular unleaded |
| Transmission | 6-speed auto with manual mode |
| Drivetrain | Rear-wheel drive (optional 4 wheel drive) |
| Additional features | Direct injection, variable valve timing, Active Cylinder managing, FlexFuel capable (can run on E85 alcohol) |
| Economy of fuel | |
| City | 14.9 mpg |
| Highway | 20.0 mpg |
| Combined | 16.9 mpg |
2015 Chevy Suburban Oil Change
- Start the engine. This will help to drain the oil more quickly And also completely.
- Place the car in A level area And use your parking brake.
- Lift the hood to locate the drain plug. It is usually situated on the lower side of the pan for oil in your engine to the left of the vehicle.
- Put the oil drain pan underneath the drain plug.
- Unlock the drain plug using the socket wrench or ratchet. Be careful, because the oil will begin draining immediately.
- Allow the oil to run off entirely. This may take just a few minutes.
- After the oil is drained remove the old filter. You may need to use A wrench to remove the oil filter to remove it.
- Spread a fine layer of oil on the gasket of the brand-new oil filter.
- Install the brand New filter with your hands until it’s tight Then tighten it a further 1/4 turn using the wrench for the oil filter.
- Install the drain plug And secure it tightly.
- Add the fresh oil. Be careful not to overfill your engine. The capacity of your Suburban’s 2015 engine will be 8 cubic quarts.
- Verify the level of oil by using the dipstick. The oil level should be in between the marks of the dipstick.
- Begin the engine, and allow it to run for a couple of hours. Then, turn off the engine, And check whether there are leaks in the drain pipe as well as the oil filter.
- Get rid of the old oil And filter in a proper manner.
FAQs – 2015 Chevy Suburban Oil type
What is the oil capacity of a Chevy Suburban?
The oil change intervals can be 12 months. If your Chevy Suburban falls within these years, the oil capacity is 8 quarts. The recommended viscosity is 0W-20. 3. Chevy Tahoe Your Chevy Tahoe SUV can take up to 8 quarts of oil depending on the year and engine model.
What kind of oil do you put in a Chevy 53?
There are just two types of engine oils recommended for vehicles with Chevy 5.3 engines. The oils are 5w30 and 0w20. GM Dexos-approved 5w30 oils are the best for your 1999 – 2013 Chevy 5.3 vehicles. However, the 2014 Chevy Suburban 5.3 and Tahoe 5.3 can use 5w30 oils, too.
How many quarts of oil does a Chevy SSR take?
As rugged as the Chevy SSR appears, the 2003 – 2004 models with 5.3 engines take just 6 quarts of oil. There are just two types of engine oils recommended for vehicles with Chevy 5.3 engines. The oils are 5w30 and 0w20. GM Dexos-approved 5w30 oils are the best for your 1999 – 2013 Chevy 5.3 vehicles.
How often should I change the oil in my Chevy Silverado?
Chevrolet recommends that you change oils at 3,000-mile intervals. However, some drivers do not change oils until after 12 months. Now, here’s the truth, if you’re using the “best-fit” oil for your engine, you need not bother about an oil change until after 7,500 – 10,000 miles.
People Also search for 2015 Chevy Suburban oil type
| 2015 suburban 5.3 oil capacity |
| 2015 chevy suburban oil capacity |
| best oil for chevy suburban |
| 2021 suburban oil capacity |
| 2015 chevy Tahoe oil type |
| oil for the 2015 suburban |
| 2001 chevy suburban oil type |
| 2008 chevy suburban oil type |