Kubota RTV 1100 Oil Type, Capacity, Filter, & Change Cost


Kubota RTV 1100 Oil Type: Changing the oil inside the Kubota RTV 1100 is an essential part of regular maintenance. It keeps the engine running efficiently and helps prevent premature wear and wear.

In this article, I’ll discuss the kind of oil you should use as well as the capacity, filter, and expense of changing the oil.


Oil type: The recommended oil for the Kubota RTV 1100 is a 4-cycle diesel engine oil that has a CF rating of CF or greater. It is possible to use synthetic or mineral oil but synthetic oil offers greater protection for your engine and last for longer.

Capacity for Oil: The oil capacity for the Kubota RTV 1100 is 4.2 Quarts. Make sure you add new oil slowly and cautiously making sure to check the level regularly to prevent overfilling.


Oil filter: The oil filter used in the Kubota RTV 1100 model is a cartridge filter that has the part number 16431-42010. It is essential to change the filter when you change the oil.

Oil change cost: The cost to change the oil in the Kubota RTV 1100 vehicle will differ according to the type of oil you choose to use as well as the cost of labor by your mechanic. You can anticipate to spend between $50 and $75 for a simple oil change.

Kubota RTV 1100 Oil Type

Kubota RTV 1100 Oil Type

The recommended oil to use with the Kubota RTV 1100 is a 4-cycle diesel engine oil, with a CF rating at CF at or above. It is possible to use synthetic or mineral oil however synthetic oil offers greater protection for your engine and lasts for longer.

Here are a few examples of the types of oil that are suitable:

  • Kubota Super UDT SAE10W-30
  • AMSOIL SAE 10W-30 Synthetic Small Engine Lubricant
  • Lucas Oil SAE 10W-30 Synthetic Motorcycle Oil
  • Valvoline SynPower SAE 10W-30 Full-Synthetic Diesel Engine Oil

Note that this is a general guideline and it is recommended to check the Kubota owner’s manual for more specific suggestions.

Kubota RTV 1100 Oil Capacity

It is vital to know that it’s the entire power of your engine’s oil supply comprising the filter. In order to change the oil you’ll only require about 4 quarters (3.7 milliliters) of fresh oil since certain amounts of old oil may stay in the filters.

Make sure you add new oil slowly and cautiously and check the level often to ensure that you do not overfill. Overfilling the crankcase of your oil can result in engine damage.

After adding new oil, you can start the engine and allow it to run for a couple of minutes. After that, you should check the level of oil and add additional oil if required.

Kubota RTV 1100 Oil Filter

This Kubota RTV 1100 oil filter is a spin-on type of filter that is situated on the right-hand left side of your engine at the bottom. Its Kubota model number of the oil filter is 16271-32090.

Here are a few other well-known oil filter models and parts numbers that work for this model: Kubota RTV 1100:

  • WIX 51344
  • ACDelco PF1230
  • Baldwin B7020
  • Fram PH4458
  • Purolator PL24458
  • Mobil MO4458

It is vital to know that the Kubota RTV1100 has a break in the serial number in the case of an oil filter. RTV 1100s that have serial numbers lower than and equal to 31002 utilize the oil filter described above. 

RTV 1100s that have serial numbers greater than 31002 require another oil filter using a Kubota Part number of 16271-39170.


Oil Change Kubota RTV 1100  

  1. It is important to warm up the engine for a couple of minutes. This will make the oil flow more smoothly.
  2. Switch off the engine and remove the hood.
  3. Place the drain pan for oil underneath the plug for draining oil.
  4. Make use of a socket or wrench to remove the drain plug. Be cautious of burning yourself with scorching oil.
  5. Let the oil be drained from the pan.
  6. After the oil has been drained and the drain plug is replaced, tighten it up using the socket or wrench.
  7. Transfer the drain pan for oil beneath the filter.
  8. Use a socket or wrench to loosen the filter on your oil.
  9. Clean the filter from the oil and let the oil run off in the drain pan.
  10. Apply a thin layer of oil that is new to the gasket on the brand-new oil filter.
  11. Install the new filter with your hands until it’s secure. Do not over-tighten.
  12. Take off the drain pan for oil then dispose of the oil appropriately.
  13. Make use of the funnel in order to apply oils to your engine.
  14. Make sure the oil is at the right level, and add additional oil if required.
  15. Get the motor started and allow it to run for a while to see if there are leaks.
  16. Close the hood, and you’re done!

People Also Searches kubota rtv 1100 oil type

kubota rtv 1100 oil specifications
kubota rtv 1100 oil change
kubota rtv 1100 engine oil
kubota rtv 1100 oil capacity
kubota rtv 1100c oil filter
kubota rtv oil change
kubota rtv x1100c oil type
kubota rtv x1100c oil change


Thank you for taking the time to read this article about Kubota’s RTV 1100 Oil type. I hope that you find the information useful. If you’ve got any other questions, do not hesitate to get in touch with me.

I also want to express my gratitude to Kubota Corporation. Kubota Corporation for providing me with the information I needed for this article. Without their assistance, the article would not be feasible.

Last but not least, I’d recommend that you spread this information to your family and friends. The more people are aware of the Kubota RTV1100 oil kind the more beneficial.

Thank you again for your time reading!

For more posts visit our website: https://engineoiil-capacity.com/

FAQs – Kubota RTV 1100 oil type

What is the MSRP of a Kubota RTV xg850?

The offer is only available to models that are in stock and have US$13,651 MSRP for the RTV-XG850G A, RTV-XG850CAG, and RTVXG850EVG. $0 Down, 0% A.P.R. financing for the duration of up to sixty months or instant rebates of $1500 are available for the purchase of new Kubota RTV-XG850 Series products at participating dealer’s stock inventory.

How to maintain Kubota genuine parts for parts replacement?

Use only KUBOTA genuine parts for parts replacement to maintain machine performance and to assure safety. • Gaskets and O-rings must be replaced during reassembly. Apply grease to new O-rings or oil seals before assembling.

When does the 2022 Kubota RTV X900 go on sale?