GMC Sierra 1500 Oil Type, Capacity, Filter & Change Cost

The procedure to change the oil inside the motor of the GMC Sierra 1500 is a fairly simple job that you can accomplish at home, using just a handful of tools. The steps below will guide you through the procedure:

1. Make sure that your vehicle is level surface before turning off your engine.
2. Lift the hood then look for the cap, which is filled with oil.
3. Remove the cap from the oil filler, then put it away.
4. Place a drainage pan under the plug to drain the oil.
5. Use the socket or wrench to loosen the drain pipe.
6. Let the oil drain into the pan to drain.
7. After the oil has passed through, it’s time to change the drain connector and lock it using the wrench or socket.
8. Remove your old filter.
9. Apply a thin layer of fresh oil on the filter that you just replaced.
10. Make sure to install the brand-new filter using your hands until you feel it is secure.
11. The drain pan needs to be removed from the side of the truck that is underneath it.
12. Inject new oil into the engine through to the filler neck.
13. Replace the cap of the filler with oil, then shut it.
14. Start the engine and then let it run for about a couple of minutes.
15. Check the oil level and add more oil in the event of need.
16. Shut off your engine and then close the front of the hood.

People Also Searches GMC Sierra 1500 oil type

Conclusion

Selecting the correct oil for the right oil type for your GMC Sierra 1500 is essential to ensure its performance is optimal and extend its lifespan.

Check out the manufacturer’s suggestions and take into consideration your driving habits and the local climate before deciding between synthetic and conventional oils according to your requirements and budget.

For more information visit their official website at

FAQs – GMC Sierra 1500 oil type

What kind of oil does a 2015 GMC Sierra 1500 take?

A 2015 GMC Sierra 1500 requires 5W-30 or 10W-30 engine oil. Synthetic or conventional oil that satisfies the GM dexos1TM criteria is suggested. The owner’s manual should also be consulted for precise oil recommendations.

How many quarts of oil does a 2018 GMC Sierra take?

Oil type for a 2018 GMC Sierra 1500 It has three engines, and all of them are fully synthetic. The 4.3l v6 engine has a 6-quart capacity. It utilizes SAE 5W 30 synthetic oil, while the 5.3L and 6.2L V8 engines each hold 8 quarts of SAE 0W-20 oil.

How often to change the oil in a GMC Sierra?

Full synthetic oil can last longer than other oils. It depends upon the type of vehicle and the brand of synthetic oil you are using in it. You should check the user manual to get information about oil change intervals. Typically some models need to change oil every 3000 to 5000 miles.

What kind of engine oil do I use on the GMC Sierra 1500?

GMC suggests using a premium, dexos1(r)-approved synthetic blend or full synthetic oil that has 5W-30 viscosity for the majority of operating conditions.

Can I utilize conventional oil instead of the synthetic one within my GMC Sierra 1500?

Yes you can utilize traditional petroleum in GMC Sierra 1500, but it is recommended to use synthetic blends or fully synthetic oil to guarantee more protection and better performance.