Dana 35 oil type tj

Dana 35 gear oil… Jump to Latest Follow 1 – 8 of 8 Posts. X … Typically GL5 75W-90 or 75W-140 (heavy duty use) gear oil. If you have a limited slip diff you may need the friction modifier additive depending on the gear oil. The label should say if it is needed. … TJ Wrangler Technical Forum General Discussion YJ Wrangler Technical Forum XJ Cherokee Technical …

FAQ dana 35 oil type tj

How much oil does it take to Lube a Dana 30?

It should take about 3.5 pints, the dana 30 would take 2.5 pints More sharing options… I have always liked Mobil synthetic products. However, for our 1999 Jeep XJ Cherokee Dana 30 and Chrysler 8.25″ axles with ARB Lockers, I use Mopar 75W-120 synthetic gear lube.

Can a Dana 35 axle have a C-clip design?

According to the 1989 factory service manual (U. S. edition), your rear Dana 35 axle should not have a C-clip design axle. You should have press-on axle shaft bearings and bearing retainer plates at the outer tube ends of the axle housing.

How much Dana 30 to add to a 75W90?

Alberto, most likely you have a D35 in your yj. You could confidently use mobile1 75w90 with lsd additive. It should take about 3.5 pints, the dana 30 would take 2.5 pints

Is there a friction modifier for Dana Trac-Lok axles?

Wynn’s and others make friction modifier, too, be sure it’s for a Spicer/Dana Trac-Lok axle. One bottle should do it.